 |
| ||
 | |||
|
Fog Light Wiring Kits
Wiring kits are available for some models to relay the stock fog lights or to add fog lights to a car not originally equipped with them. Kits for adding fogs DO NOT include a switch or specifics on where to connect the switch to fuse box power. The kits take advantage of pre-wiring in some models for an oem style install.
pictured above: A2fog
Mk 2 Golf/Jetta fog relay kit * A2fogN $55 (for cars not fog equipped) * This kit has a wire that just plugs onto the tab on the factory fog switch, rather than using the oem harness plug. The oem plug can be provided on the wires for $20 additional. You must provide an oem Mk 2 fog switch.
Mk 2 Golf/Jetta fog relay kit A2fogY $55 (for cars with factory fogs)
Corrado fog relay kit Cfog $50
Dash harness for early Corrado switch CDash1 $45
Dash harness for late Corrado switch CDash2 $35
Passat B3 fog relay kit B3fog $55
Passat B4 fog relay kit B4fog $55
Mk 3 Golf/Jetta fog relay kit A3fogN $50 (for cars not fog equipped)
Mk 3 Golf/Jetta fog relay kit A3fogY $55 (for cars with factory fogs)
Mk 4 Golf/Jetta fog relay kit A4fog $50 (for adding ecode fogs to non-fog car)
Mk 4 Golf/Jetta rear fog wiring kit A4rear $13 (note: includes clear bulb. I do not have red bulbs)
pictured above: A4fog Use this to connect the fog lights in your new E-codes to a euro switch on any Mk 4 VW
NEW! Mk 5 fog relay kit
If you are adding oem fog lights to your Mk 5 VW, you will need a wiring kit. Factory fog lights are wired through the CECM and are computer controlled. However, many lowline and midline CECM controllers do not support fog lights. Highline controllers do. You have to use a vag-com to check your CECM. The advantage of this method is oem-style switching and detection of burned out bulbs.
Whether your CECM supports fog lights or not, you can use the relay kit instead of the oem kit. The advantage is the relay switching power from the battery for maximum voltage to the bulbs. Burned out bulbs cannot be detected with this kit. NOTE: This kit includes the updated reed relay input interface to insure that it can be driven by the low current source in the Mk 5 euroswitch.
US-spec fog lights use 9006 bulbs and euro-spec use H11 bulbs. You must indicate which bulbs you are using so that the proper plugs will be provided.
Mk 5 Golf/Jetta fog light wiring kit A5fog $50 (connects to CECM like oem)
Mk 5 Golf/Jetta fog relay kit A5relay $85 (shown below with H11 plugs)
WIRING KITS for MANUAL HEADLIGHT LEVELERS
Some European headlights come with leveling motors or can have them added. Here are a few wiring kits for connecting the manual leveling system.
NOTE: NOT for use with automatic leveling system.
Corrado with early style leveler switch uses the CLEV1 kit pictured above.
Corrado w/ early (G60) style switch CLEV1 $55
Corrado w/ late (SLC) style switch CLEV2 $55
B3 Passat wiring kit B3LEV $55
B4 Passat wiring kit B4LEV $55
Note: Kits do NOT include motors and control rheostat.
Mk 4 leveler kit (shown above)
fits all Mk 4 VW's with e-code headlights or oem HID's, with manual leveler motors requires rheostat switch (not sold here)
Mk 4 Golf/Jetta leveler kit for ecodes A4LVLR $55
Mk 4 Golf/Jetta leveler kit for oem HIDs HIDLVLR $55
Questions? email info@eurowires.net
| ||
|
Home Page | Grounding Kits | Fog and Leveler Kits | Headlight Plug Converters | Headlight Harnesses | CIS-E Products | About Me and How to Order
relay harness, relays, Bosch, bright headlights, plug converters, adapters, ground kit, grounding kit,
|
